The Crown DCi4 600N Network Amplifier has been specifically engineered to exceed the industry's highest standards. This is exactly what the Crown reputation is best known for. They continue to innovate and raise the bar. The Crown DCi4 600N Network Amplifier was built to power low impedance or even 70 or 100 volt speaker systems. Check out the Crown DCi4 600N DriveCore Amplifier's amazing features:
- 300 watts into 2 ohms.
- 600 watts into 4 ohms.
- 600 watts into 8 ohms.
- 600 watts into 70 volts.
- 600 watts into 100 volts.
- 20.1 pounds.
- 20Hz to 20kHz frequency response.
- 4 individual channels.
-Crown's newest technology, along with their patented DriveCore technology have elevated these amps to a new level and new generation of PWM technology in any Class D amplifier. -Minimum Power Ratings – Crown DCi amplifiers promise to provide the least rated power in specifications over the longest period of time. They will beat out any competition. -Direct Drive (Constant Voltage) capabilities on a channel by channel basis for 70Vrms or 100Vrms amplification eliminating the need for a step up frequency limiting transformer for the highest sound quality. -HiQnet Audio Architect supported. - PFC universal power supply gives you top of the line efficiency. This has been created to deliver the most power anywhere this amp is located. -Universal AC input accepts 100 – 240VAC, 50/60Hz (±10%). -DriveCore technology includes five patents that Crown also uses in their touring amplifier I-Tech HD4. Making this amp the best in its class when it comes to versatility and durability. -TCP/IP based protocol in HiQnet for network monitoring and control. -The Crown DCi4 600N Network Amplifier's amazing cooling system directs airflow toward parts that need cooling the most, bringing the most efficiency and minimizing noise and heat. -BLU Link compatibility – low latency, digital audio bus, fault tolerant,able to route 256 channels with standard Category 5e cabling (over a distance as far as 100m between devices), delivers a unique level of routing and flexibility.
Network Monitoring and Control features include:
• Continuous Load Monitoring. • Comprehensive Error Reporting. • Pilot Tone Monitoring. • Programmable General Purpose Input/Output (GPIO) Ports.
Digital Signal Processing (DSP) features include:
• LevelMAXTM Limiters for Inputs and Outputs with Thermal Limiting. • Input Compressor. • Input and Output Delay. • Input and Output EQ. • Signal Generator. • Crossover. DOWNLOAD user manual
Crown DCi4 600N DriveCore Amplifier Specifications:
Dual Mode (All Ch. Driven)
| 2-ohm: |
300W. |
| 4-ohm: |
600W. |
| 8-ohm: |
600W. |
| 16-ohm: |
300W. |
| 70Vrms: |
600W. |
| 100Vrms: |
600W. |
Crown DCi4 600N DriveCore Amplifier Bridge Mono Mode (All Ch. Driven)
| 4-ohm: |
600W. |
| 8-ohm: |
1200W. |
| 16-ohm: |
1200W. |
| 140Vrms: |
1200W. |
| 200Vrms: |
1200W. |
Crown DCi4 600N DriveCore Amplifier Voltage Gain (max level settings)
| 4/8-ohm Operation: |
34dB |
| 70V Operation: |
34dB |
| 100V Operation: |
34dB |
Crown DCi4 600N DriveCore Amplifier Input Sensitivity
| 2/4/8-ohm: |
1.4V. |
| 70V: |
1.4V. |
| 100V: |
2.0V. |
Crown DCi4 600N DriveCore Amplifier Performance
| Frequency Response (at 1W, 20 hz - 20 kHz): |
±0.25dB |
| Signal to Noise Ratio (ref. Rated power, 8 Ohms, 20 Hz - 20 kHz): |
>108dB |
| Total Harmonic Distortion (at full rated power, from 20 Hz - 20 kHz): |
< 0.35% |
| Intermodulation Distortion (60Hz and 7 kHz at 4:1, from -30dB to full rated power): |
?0.35%. |
| Damping Factor (20 Hz to 100 Hz): |
>900. |
| Crosstalk (below rated power, 20Hz to 100Hz): |
>80dB. |
| Common Mode Rejection (20 Hz to 100 Hz): |
>70dB. |
| DC Output Offset (with inputs shorted): |
±10mV. |
| Input Impedance (Nomminally balanced, nominally unbalanced): |
20 kOhms, 10 kOhms. |
| Maximimum Input Level Before Compression: |
20dbu. |
| Maximimum Input Level Before Clipping: |
26dbu. |
| Required AC Mains (±15%): |
100V - 240V, 60/50Hz. |
| Cooling: |
Continuously variable speed forced air, front-to-back airflow |
| Load Impedance Stereo/Dual Mode: |
2 - 16Ohms; 70Vrms and 100Vrms |
| Load Impedance Bridge Mono: |
4 - 16Ohms; 70Vrms and 100Vrms. |
Crown DCi4 600N DriveCore Amplifier Dimensions
| Width: |
19 in. (48.3 cm). |
| Height: |
3.5 in. (8.9 cm). |
| Depth: |
14.25 in. (36.2 cm). |
| Weight: |
20.1 lbs (9.1 kgs). |
