The ISA800Ti System Amplifies are designed to meet the needs of sound system designers and contractors worldwide. Three models feature isolated 25, 70, and 100 volt outputs for distributed sound systems, while four low impedance models are rated for 2 ohm operation. 

QSC ISA800Ti FEATURES

  • Low-impedance outputs plus isolated 25, 70, and 100 volt outputs for distributed audio systems
  • Rear panel gain controls for tamper resistance; 2-dB detents allow for quick and repeatable settings
  • XLR and detachable Euro-style input connectors
  • DataPort V2 for use with DPV2-compatible signal processing accessories (XC-3, SF-3, LF-3) and DSP-3/DSP-4 (with external power supply)
  • Independent defeatable clip limiters for reduced distortion
  • Selectable high-pass filters (50 Hz or 75 Hz) protect speakers and prevent speaker transformer saturation, with minimal effect on program material
  • Two-tier Class H complementary bipolar output circuitry reduces AC power draw and waste heat by 40%
  • Front panel indicators include power, signal, and clip
  • Covered barrier strip output connectors for safety agency compliance
  • Automatic on-demand variable-speed fan: quiet normal operation, with maximum cooling when needed
  • Rear-to-front air flow helps keep equipment racks cool
  • Stereo, bridge, or parallel operating modes
  • Comprehensive protection circuitry including DC, infrasonic, thermal overload, and short circuit protection

QSC ISA800Ti Specifications

 

SPECIFICATIONS ISA280 ISA450 ISA750 ISA1350 ISA300Ti ISA500Ti ISA800Ti
  STEREO MODE, Both Channels Driven
8 ohms 20 Hz-20 kHz 0.1% THD 185W 260W 450W 800W 185W 260W 450W
4 ohms 20 Hz-20 kHz 0.1% THD 280W 425W 650W 1300W 280W 425W 650W
2 ohms 1 kHz 1% THD 430W 700W 1200W 2000W 430W 700W 1200W
  DIRECT POWER, STEREO MODE
70V 20 Hz-20 kHz 0/-0.3 dB 0.5% THD - - - 1500W - - -
  XF OUTPUT POWER, STEREO MODE
70V or 100V 50 Hz-16 kHz 0.5% THD - - - - 300W 500W 800W
25V 50 Hz-16 kHz 0.5% THD - - - - 200W 300W 500W
  BRIDGED MONO MODE
8 ohms 1 kHz 0.1% THD 600W 900W 1500W 2800W 600W 900W 1500W
4 ohms 1 kHz 1% THD 830W 1400W 2400W 4000W 830W 1400W 2400W
  XF OUTPUT POWER, BRIDGED MONO MODE
140V or 200V 50 Hz-16 kHz 0.5% THD - - - - 600W 1000W 1600W
Signal to Noise (20 Hz-20 kHz) 100 dB 100 dB 100 dB 100 dB 100 dB 100 dB 100 dB
Distortion (SMPTE-IM) Less than 0.01% Less than 0.01% Less than 0.02% Less than 0.01% Less than 0.01% Less than 0.01% Less than 0.02%
Input Sensitivity @ 8 ohms 1.15v ( 3.4 dBu) 1.07v ( 2.8 dBu) 1.07v ( 2.8 dBu) 1.24v ( 4.1 dBu) 1.15v ( 3.4 dBu) 1.07v ( 2.8 dBu) 1.07v ( 2.8 dBu)
Voltage Gain @ 8 ohms 33.4x (30.5 dB) 44.7x (33 dB) 56.2x (35 dB) 64.0x (36.1 dB) 33.4x (30.5 dB) 44.7x (33 dB) 56.2x (35 dB)
Output Circuitry Class AB Class AB Class H Class H, 3 Tier Class AB Class AB Class H
THX Approved - THX Approved THX Approved - - - -
Weight - Net 36 lbs (16.3 kg) 42 lbs (19 kg) 47 lbs (21.3 kg) 68 lbs (30.8 kg) 44 lbs (20.0 kg) 49 lbs (22.3 kg) 57 lbs (26 kg)
Weight - Shipping 42 lbs (19.1 kg) 48 lbs (22 kg) 53 lbs (24.0 kg) 77 lbs (34.4 kg) 50 lbs (22.7 kg) 55 lbs (25 kg) 63 lbs (28.6 kg)
  ALL MODELS
Distortion (Typical) 20 Hz-20 kHz: 10 dB below rated power 1.0 kHz and below: full rated power Less than 0.03% THD, 4 ohms and 8 ohms Less than 0.03% THD, 4 ohms and 8 ohms
Frequency Response 10 dB below rated output power ISA 280, 450, 750 and 1350:  20 Hz-20 kHz, 0/-1 dB; -3 dB points: 5 Hz and 50 kHz ISA 300Ti, 500Ti and 800Ti:  Direct outputs: -3 dB @ 50 Hz, -0.5 dB @ 20 kHz; XF outputs: 50 Hz-16 kHz, 1/-3 dB
Damping Factor (direct outputs) Greater than 200 at 8 ohms, ISA 1350 greater than 250
Output Regulation (isolated outputs) Less than 1.5 dB
Input Impedance 10 k ohms unbalanced, 20 k ohms balanced
Input Clipping 10 Vrms ( 22 dBu)
Cooling Continuously variable speed fan, back-to-front air flow
Connectors, each channel Input: Active balanced; 3-pin Euro-style detachable terminal block and XLR (pin 2 ) Output: Covered barrier strips DataPort V2: HD-15 connector
Controls Front: AC switch Rear: Ch. 1 and Ch. 2 gain knobs, 10-position DIP switch
Indicators PWR-ON: Green LED; SIGNAL: Green LED (1 per channel); CLIP: Red LED (1 per channel)
Dimensions 19" (48.3 cm) rack mounting, 5.25"(13.3cm) tall (3 rack spaces), 15.9" (40 cm) deep (from front mounting rails)
Amplifier Protection Full short circuit, open circuit, thermal, ultrasonic, and RF protection; Stable into reactive or mismatched loads
Power Requirements 120, 230, VAC, 50-60 Hz
Load Protection On/off muting; Triac crowbar: ISA 750, 1350 and 800Ti; AC coupling: ISA 280, 300Ti, 450 and 500Ti
List price: $1,640.00
Price: $1,640.00