The Shure WL184 is a super-cardioid subminiature lavalier microphone with signal characteristics ideal for general sound reinforcement applications. The super-cardioid pick up pattern provides adequate rejection of off-axis ambient signal that can cause noise and feedback. The low-profile subminiature design is ideal for applications where the microphone must be concealed. The hardwired 4 foot cable terminates to a 4-pin TA4-female connector which is compatible with Shure wireless transmitters and power supplies.
- Wide dynamic range and frequency response for accurate sound reproduction across the audio spectrum
- Interchangeable cartridges that provide an optimal choice for each application
- Rotatable tie-clip that pivots in 90 degree increments for placement flexibility
- Supplied snap-fit foam windscreen that controls breath noise and stays on securely
- Supplied dual tie clip holds two microphones for dual miking applications
Recommended for sound reinforcement applications requiring high rejection of ambient noise and narrow pickup angle, the WL184 is a supercardioid lavalier microphone with a 115 degree pickup angle. It has a 1.2 meter (4 ft.) cable terminated with a miniature 4-pin mini connector. Included tie clip can be rotated in 90 degree intervals for placement flexibility. Use of windscreen highly recommended.
Shure Wl184 Specifications
| Transducer |
Electret Bias |
| Polar Pattern |
Super-Cardioid |
| Frequency Response |
50Hz to 17kHz |
| Dynamic Range (Typical) |
102dB |
| Signal-to-Noise Ratio |
27dB SPL (A-weighted) |
| Maximum Input Sound Level |
129.5dB |
| Power Requirements |
Regulated Nominal 5 Vdc (2 Vdc to 10 Vdc) |
| Output Impedance |
18 kHz |
| Output Connectors |
TA4-Female |
| Pad |
No |
| Low Frequency Roll-Off |
No |
| Dimensions |
Cable length: 4 foot (1.2 meter) |
| Weight |
not specified by manufacturer |
